Q7 Quattro V6-3.6L (BHK) (2007)
Trunk / Liftgate Weatherstrip: Service and Repair
Rear Lid Seal
‹› Remove rear lid before installing seal.
‹› Hinge lid must be disconnected for this.
1
Gasket for rear lid
‹› Removal:
-
Unclip trim panels on C-pillar and on roof.
-
Open rear lid and pull off seal at C-pillar to the side
-
Pull off seal from body flange in longitudinal direction at roof and at rear cross panel on bottom.
‹› Installing:
-
When installing, vulcanized seal butt joint - arrow - must led in center of vehicle.
-
Insert seal through between roof and lid hinge.
‹› Press seal all around onto body flange.
‹› Re-install lid on lid hinge.
2
Rear lid