Q7 Quattro V6-3.6L (BHK) (2007)
CAUTION!
Without this wood block inserted, there is the danger of injury when lower control arm moves back to initial position.
-
Install tools onto wheel bearing housing, as shown in illustration.
1. Nut (T10230/2)
2. Press piece (T10230/13)
3. Thrust pad (T10230/6)
4. Tube (T10230/5)
5. Press piece (T10230/4)
6. Tube (T10230/3)
7. Thrust plate (T10230/7)
8. (VAS 6178)
CAUTION!
Before pressing out, place (V.A.G 1383 A) with (V.A.G 1359/2) below Hydraulic Cylinder. (VAS 6178) can fall down at end of pressing
out procedure.
-
Press bonded rubber bushing out.
Pressing in