audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Subframe|Page 19020 > < Procedures|Page 19017
Page 1
background image

Front Subframe: Removal and Replacement
Subframe

Subframe

Special tools, testers and auxiliary items required

‹› The following tools can be used on all engine versions. The tools needed for working on a specific engine are described. 

‹› Engine support bridge (10 - 222 A)

‹› Adapter (10 - 222 A /22)

‹› Bracket with spindle and hook (10 - 222 A /10)

‹› Engine Sling (2024 A)

‹› Engine Support Basic Set (T40091)

‹› Engine Support Supplement Set (T40093)

‹› Engine Support (T10014) (only needed with 3.0L TDI)

‹› Ball joint puller (T10187)

‹› Hose clamps up to dia. 25 mm (3094)

‹› Scissor lift table (VAS 6131)

‹› Support Set (VAS 6131/10)

‹› Supplementary set (VAS 6131/11)

‹› Supplementary set (VAS 6131/13)

Removing

Brief description:

Subframe is removed using scissor lift table. Front mounting points of engine carrier must be secured using shorter bolts. Subframe is removed
together with the following: Steering gear, front axle drive, lower control arm and wheel bearing housing. The suspension struts with mounting
brackets and upper control arms remain on vehicle.

Affects vehicles with air suspension

-

Place vehicle on hoist. Refer to => [ Positioning Vehicle on Hoist and Wheels ] See: Steering and Suspension/Suspension/Service and
Repair/Procedures/Positioning Vehicle on Hoist and Wheels. 

-

Perform system vent using (VAS 5051B). Refer to => [ System, Venting or Filling ] See: Steering and Suspension/Suspension/Suspension Control
( Automatic - Electronic )/Service and Repair/System, Venting or Filling.

Applies to all

-

Remove front wheels.

-

Remove noise insulation. Refer to => Radiator Support See: Lock Carrier..

-

Remove the left front wheel housing liner.

Subframe|Page 19020 > < Procedures|Page 19017