Q7 Quattro V6-3.6L (BHK) (2007)
- Arrows - point in direction of travel.
Holes - A - are parallel to direction of travel
Cutouts - B - face perpendicular to direction of travel
-
Place the tools on the front bonded rubber bushing as shown in the illustration.
1. Press piece (T10301/7)
2. Bonded rubber bushing
3. Thrust pad (T10301/6)
4. Hydraulic cylinder (VAS 6178)
5. Washer (T10205/4)
6. Nut (T10301/2)
7. Spindle (T10301/1)
-
Press in bonded rubber bushing until shoulder lies gap-free at subframe sleeve. Tension and re-press over cylinder several times.
‹› After replacing bearing, remove abrasions on subframe with a file.
‹› Correct paint damage on subframe with corrosion protection, primer and black top coat.
-
Place the tools on the rear bonded rubber bushing as shown in the illustration.