Q7 Quattro V6-3.6L (BHK) (2007)
^
Remove the side cover
^
Note: Wiring runs through this cover
^
Press wire connector clips together and remove the connector.
^
Remove the cable clip as show in photo.
^
Remove the screws; Torx Tx 25; 0.5 NM
^
Replace the Electric Seat Switch Module
^
Connect and fasten the cable and Module with screws and cable clip.
^
Wiring must be inserted into the wiring guides in the points shown.
^
Install the front cover by pressing the cover in and down.
^
Ensure the clips are secured at the marked points
^
Attach the cover from top to bottom at the marked points by inserting the top into the upper U-channel.