Q7 Quattro V6-3.6L (BHK) (2007)
-
Panel cable 3 inserted sideways in tilting mechanism.
Rear corner pieces and tilting mechanism, installing
-
Installation is reverse of removal, noting the following.
-
Slide tilting mechanism with cable into guide rail.
-
Only slide tilting mechanism with screwdriver on plastic guide, the same as during removal but in reversed direction.
-
Install bolts - 2 - on tilting mechanism - 3 - in frame - 1 - and tighten to 2 Nm.
-
Adhesive residue must be cleaned from adhesive surfaces on frame or adhesive channel in corner piece.
-
Apply 1K MS assembly adhesive (D 172 090 A2)- 2 - as shown in adhesive channel on left and right corner piece - 1 -.