Q7 Quattro V6-3.6L (BHK) (2007)
6 -
Torx bolt
7 -
Protective plate
8 -
Brake pads
^
With wear indicator
^
With adequate wear, warning light in instrument cluster comes on
^
Checking thickness: Work procedures; Brake pads, front and rear: Checking thickness
^
Must always be replaced together on both sides of axle
9 -
Wire for brake pad wear indicator
10 -
Securing cotter pin
11 -
Pad retaining pin
12 -
Retaining spring
13 -
Bracket
^
Bolt to brake caliper housing
14 -
Hex head bolt
^
Torque specification 8 Nm
15 -
Spring clamp
16 -
Brake line
^
Torque specification 14 Nm
^
Screw into brake caliper housing
^
Do not unscrew brake line when replacing brake disc
17 -
Brake hose
^
Do not unscrew brake hose when replacing brake disc
^
Make sure that lugs are properly seated in grooves in bracket.
18 -
Spring dowel sleeve
19 -
Compression spring
20 -
Pull-spring
^
Component location: At adjustment nut
^
Larger number of spring coil
^
Can be easily bent by hand
21 -
Pull-spring
^
Component location: At spreader
^
Smaller number of spring coil
^
Cannot be easily bent by hand
22 -
Spreader
23 -
Adjustment nut
24 -
Brake shoes
^
Without wear indicator
^
Minimum pad thickness 1 mm
25 -
Brake disc cover plate
^
Torque specification 20 Nm
26 -
Rear brake cable