Q7 Quattro V6-3.6L (BHK) (2007)
/Page-4102002.png)
-
Slide brake line - B - against stop - A - in flaring tool.
Note: Brake line must contact stop when hex socket heat screws are tightened, otherwise flared head will not be formed correctly.
-
Clamp brake line in flaring tool until it cannot be moved any more. Fold stop - A - up and tighten hex socket head screws diagonally with angle
screw driver - C -.
-
Turn spindle to stop in flaring tool.
-
Turn spindle back.
-
Loosen hex socket head screws diagonally.
-
Remove brake line from flaring tool, clean and check brake line and flared head.
Briefly rinse part of brake line remaining in vehicle.
-
Connect brake filler bleeder unit VAS 5234, place bleeder container hose on flanged head of brake line and run brake filler bleeder unit VAS 5234
briefly until some brake fluid runs through.
-
Blow out brake line to be inserted with compressed air.
