Q7 Quattro V6-3.6L (BHK) (2007)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Front Axle
Speed Sensor, Front Axle
Removing
-
Raise vehicle.
-
Separate speed sensor and speed sensor wiring connector - 1 -.
-
Remove bolt - 2 - from wheel bearing housing.
-
Remove ABS speed sensor from wheel bearing housing.
Installing
-
Before inserting wheel speed sensor, clean inner surface of bore hole and coat sensor completely with Polycarbamide grease (G 052 142 A2).
-
Insert the speed sensor into the hole in the wheel bearing housing and tighten bolt to 8 Nm.
-
Connect speed sensor to speed sensor wiring.