Q7 Quattro V6-3.6L (BHK) (2007)
Cruise Control Switch: Service and Repair
Cruise Control Switch E45, Removing And Installing
Removing
-
Remove Steering Column Switch Module (SCSM).
NOTE: Steering must be in center position (wheels in straight ahead position) when removing and installing return spring with slip ring.
-
Carefully release catches - arrows -.
-
Remove airbag spring/spiral spring with slip ring - 2 - with Steering Angle Sensor G85 - item 1 - from Steering Column Switch Module (SCSM).
-
Remove screws - arrows - and remove Steering Column Electronic Systems Control Module J527 - item 2 - from steering column switch module.
-
Disengage Cruise Control Switch E45 - item 1 - at steering column switch module.
Installing
Install in reverse order, observing the following:
-
Make sure all fasteners and electrical connectors are properly engaged.
-
Install Steering Column Switch Module (SCSM).
Tightening torques
Steering Column Switch Module (SCSM) to Steering Column Electronic Systems Control Module J527: 0.65 Nm
Windshield Wiper/Washer Switch E22 to Steering Column Electronic Systems Control Module J527: 0.65 Nm
Cruise Control Switch E45 to steering column switch module and Steering Column Electronic Systems Control Module J527: 0.65 Nm