Q7 Quattro V6-3.6L (BHK) (2007)
Engine Oil: Removal and Replacement
Engine oil draining and replacing filter
Warning!
Oil extraction not permitted with various engine types!
Special tools and workshop equipment required
-
Oil extractor - V.A.G 1307 A -
or
-
Oil extractor - V.A.G 1358 A -
-
Tension band - 2171-1 -
-
Oil filter wrench - 3417 -
Note:
-
To extract motor oil more quickly, use probe - V.A.G 1358 A/4 - (outside diameter 10 mm).
-
Observe waste disposal regulations!
6-Cylinder Gasoline
-
To drain oil, remove lower noise insulation on drain plug. See: Body and Frame/Sound Proofing / Insulation/Service and Repair
Note:
-
Observe waste disposal regulations!
-
Avoid engine oil drips on components in engine sequence:
-
Oil new O-rings before installation.
-
Perform the following steps in the given sequence:
-
Remove oil drain plug -1- in threaded cover and drain oil.
-
Loosen the threaded cover -2- at the hex head -1- or at the edges and remove it.
-
Clean sealing surfaces at cap and at oil housing.
Installing