Q7 Quattro V6-3.6L (BHK) (2007)
/Page-2197003.png)
‹› With cylinder head installed, holes in cylinder head seal are only half visible.
CAUTION!
The cylinder head seal could be damaged.
‹› Do not kink cylinder head seal when bending.
‹› A kinked cylinder head seal must be replaced.
-
Bend end of cylinder head seal down slightly - arrows - until upper sealing surface on cylinder head seal and cylinder head can be cleaned.
-
Clean top and bottom of cylinder head seal, it must be free of oil and grease.
-
Cut tube nozzle at front marking (dia. approximately 2 mm).
CAUTION!
The cylinder head seal could be damaged.
‹› Do not kink cylinder head seal when bending.
‹› A kinked cylinder head seal must be replaced.
-
Lightly coat top and bottom cylinder head seal sealing surfaces with lubricant by bending seal down slightly again - arrows -.
