Q7 Quattro V6-3.6L (BHK) (2007)
increase uniformly.
-
Using the scan tool, check the throttle valve position (absolute) at Wide Open Throttle (WOT) stop:
-
End diagnosis and switch ignition off.
If the specified values are not obtained:
-
Disconnect the Throttle Valve Control Module (J338) electrical harness connector - 1 -.
Checking resistance
-
Using a multimeter, check the Throttle Drive (for Electronic Power Control (EPC)) (G186) at the Throttle Valve Control Module (J338) terminals
3 to 5 for resistance.
Specified value: 1.0 to 5.0 ohms (at 20° C)
If the specification was not obtained:
-
Replace the Throttle Valve Control Module (J338).
If the specification was obtained: