Q7 Quattro V6-3.6L (BHK) (2007)
-
Using a multimeter, check the Heated Oxygen Sensor (HO2S) electrical harness connector - 1 - terminals 1 to 5 for voltage.
Specified value: 0.400 to 0.500 Volts
-
Switch the ignition off.
If the specified value was not obtained:
-
Replace the Heated Oxygen Sensor (HO2S) (G39) or the Heated Oxygen Sensor (HO2S) 2 (G108).
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Replacing ] See: Engine Control Module/Service and
Repair/Engine Control Module, Replacing.
-
Using a Multimeter, check the Heated Oxygen Sensor (HO2S) (G39) or the Heated Oxygen Sensor (HO2S) 2 (G108) electrical harness connector
terminals to the Engine Control Module (ECM) (J623) electrical harness connector T94 terminals for an open circuit.