Q7 Quattro V6-3.6L (BHK) (2007)
Specified value: 2.5 to 10.0 ohms (at approx. 20° C)
If the specification was not obtained:
-
Replace the faulty Heated Oxygen Sensor (HO2S).
If the specification was obtained:
Checking voltage supply
Switch the ignition on.
-
Using a multimeter, check the Heated Oxygen Sensor (HO2S) electrical harness connector terminal 3 to the Engine Component Power Supply
Relay (J757) terminal 2/87 for voltage.
Specified value: Battery voltage.
Switch the ignition off.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Ground (GND), or an Open circuit.
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specification was obtained:
Checking Ground (GND) activation
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box..
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Replacing ] See: Engine Control Module/Service and
Repair/Engine Control Module, Replacing.
-
Using a multimeter, check the Heated Oxygen Sensor (HO2S) electrical harness connector to the Engine Control Module (ECM) (J623) electrical
harness connector T94 for an open circuit.