Q7 Quattro V6-3.6L (BHK) (2007)
-
Pull right locking flange with seal out of fuel tank a bit.
-
Disconnect electrical connectors -1 - and - 2 - on underside of right locking flange.
-
Disconnect fuel line - arrow - by pressing release button.
-
Lay aside right locking flange with auxiliary heater intake line connected.
NOTE: Ignore items -1 to 4-.
-
Grasp in fuel tank opening and remove Fuel Level Sensor G through guide - arrow 2 while pressing locking tab - arrow 1 -.
NOTE: Fuel Level Sensor G is shown without fuel tank to provide a better illustration.
Installing
-
Tightening torque.
Installation is in reverse order of removal, note the following:
NOTE: Replace seal.
-
Insert Fuel Level Sensor G into guide until it engages audibly.