Q7 Quattro V6-3.6L (BHK) (2007)
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
-
Repair any damage found to the electrical harness connector.
If the electrical harness connector is not OK:
-
Repair the malfunction.
If the electrical harness connector is OK:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Transmission Control Module (TCM) (J217).
-
Using a multimeter, check the Multi-Function Transmission Range (TR) Switch (F125) electrical harness connector terminals to the Transmission
Control Module (TCM) (J217) electrical harness connector T52 terminals for an open circuit.