Q7 Quattro V6-3.6L (BHK) (2007)
Specified value: 1.5 ohms Max.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
If necessary, repair the faulty wiring connection.
If no malfunction was found in the wiring and the resistance was not OK:
-
Replace the Multi-Function Transmission Range (TR) Switch (F125).
If no malfunction is found in the wiring and the resistance was OK:
-
Replace the Transmission Control Module (TCM) (J217).
Final procedures
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 03 - Read DTC Memory
2. If necessary, erase DTC memory of the Transmission Control Module (TCM) (J217). => [ Diagnostic Mode 04 - Erase DTC Memory ] See:
Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 04 - Erase DTC Memory
3. Generate readiness code. => [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.