Q7 Quattro V6-3.6L (BHK) (2007)
-
Release connector - D - and remove from Shift Lock Solenoid (N110).
-
Release connector - E - and remove upward.
-
Press tab - C - in direction - arrow 1 -.
-
Remove second microswitch - B - in direction - arrow 2 -.
-
Disengage electrical line at selector mechanism - arrow A -.
Installing
Install in reverse order of removal, note the following:
‹› Lubricate bearing areas and slide surfaces with polycarbamide grease (G 052 142 A2).
-
Guide microswitch on longer electrical line into opening under parking lock button in selector mechanism.
-
Guide shift gate - 1 - from below.