Q7 Quattro V6-3.6L (BHK) (2007)
Checking internal resistance
-
Using a Multimeter, check the Knock Sensor terminals 1 to 2 for an internal short.
Specified value: infinite (Infinity).
If the specified value was not obtained:
-
Replace the faulty Knock Sensor.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Replacing ] See: Computers and Control
Systems/Engine Control Module/Service and Repair/Engine Control Module, Replacing.
-
Using a Multimeter, Check the Knock Sensor electrical harness connector to the Engine Control Module (ECM) (J623) electrical harness
connector T60 for an open circuit.