Q7 Quattro V6-3.6L (BHK) (2007)
/Page-6138002.png)
-
Engage side airbag - 3 - in backrest with hooks - 2 -.
-
Ensure airbag cable - 4 - is routed correctly and secured.
NOTE:
-
Ensure that electrical connections are pushed in as far as stop and engage with a click.
-
Ensure wires are not pinched.
-
Replace screw - 1 -.
-
Tighten new screw - 1 - to specified torque.
-
Install front seat.
-
Mechanically adjustable seat.
-
Memory seat, electric seat.
CAUTION: Contrary to description under, battery MUST BE disconnected to remove airbag with ignition switched on. Ignition must be
on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired correctly, they may deploy
unintentionally after connecting battery. Maintain personal safety when connecting the battery by staying out of airbag deployment
areas, keeping a distance from belt tensioners/seat belts and ensuring no other people are in the vehicle interior at the moment when the
battery is connected.
-
Switch on ignition.
-
Connect battery with ignition on, procedure.
-
If the Airbag Malfunction Indicator Lamp (MIL) K75 shows a malfunction after assembly, DTC memory must be checked with Vehicle
Diagnostic, Testing and Information System VAS 5051 B , cleared and then rechecked.
Tightening torque
Component
Nm
Side airbag to backrest frame
10 *
* Replace screw
