Q7 Quattro V6-3.6L (BHK) (2007)
Discharge Air Temperature Sensor / Switch: Service and Repair
Right Footwell Vent Temperature Sensor G262, Removing and Installing
Right Footwell Vent Temperature Sensor G262, Removing And Installing
NOTE: Installed only in vehicles with "Comfort" version A/C system
-
Remove glove compartment:
-
Remove the Front Information Display Control Head Control Module J523 with its bracket.
-
Disconnect connector - B - from Right Footwell Vent Temperature Sensor G262 - A -.
-
Rotate Right Footwell Vent Temperature Sensor G262 - A - approx. 90 degrees in direction of arrow.
NOTE: If there is not enough room to rotate Right Footwell Vent Temperature Sensor G262 - A -, disengage air channel to right footwell - E -
from heating A/C unit (remove air channel - C - and slide air channel to right footwell - E - slightly downward).
-
Remove Right Footwell Vent Temperature Sensor G262 - A - from air channel to right footwell - E -.
Installing
-
Check O-ring seal - D - for damage and proper fitting.
-
Insert Right Footwell Vent Temperature Sensor G262 - A - on proper side into air channel mount - F -.
NOTE: An O-ring seal - D - is installed so that Right Footwell Vent Temperature Sensor G262 fits without play in mount - F -.
-
Connect connector - B - to Right Footwell Vent Temperature Sensor G262 - A - and check wire routing.
-
Install the remaining removed components again in reverse order.
-
Check DTC memory of front A/C control head Climatronic Control Module J255 and erase DTCs displayed if necessary. Vehicle Diagnosis,
Testing and Information System VAS 5051 in "Guided Fault Finding" function.