Q7 Quattro V6-3.6L (BHK) (2007)
Impact Sensor: Service and Repair
Drivers Side Airbag Crash Sensor G179 and Front Passengers Side Airbag Crash Sensor G180 ,
Removing and Installing
Drivers Side Airbag Crash Sensor G179 And Front Passengers Side Airbag Crash Sensor G180, Removing And Installing
Special tools, testers and auxiliary items required
-
Vehicle Diagnosis, Testing and Information System VAS 5051 B
Removing
CAUTION: Observe safety precautions for work on airbags.
-
Switch off ignition.
-
Disconnect battery ground wire.
-
Remove left or right sill panel strip.
CAUTION: Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically
discharge". This can be done by touching door striker, for example.
-
Release connector - 3 - by pressing fitting on connector in direction of Side Airbag Crash Sensor - 2 -.
-
Remove connector - 3 - from Side Airbag Crash Sensor - 2 -.
-
Remove bolts - 1 -.
-
Remove Side Airbag Crash Sensor - 2 -.
Installing
CAUTION:
-
Observe safety precautions for work on airbags.
-
Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically discharge". This can
be done by touching door striker, for example.