Q7 Quattro V6-3.6L (BHK) (2007)
CAUTION!
‹› Note location of steering arm boundary.
Large steering arm boundary contact surface - arrows - faces toward tie rod. Collar - 1 - points to steering gear - 2 -.
-
Place steering arm boundary - 1 - on steering rack.
-
Install tie rod on steering gear. Refer to => [ Tie Rod ] See: Tie Rod/Service and Repair/Tie Rod.
-
If steering arm boundary was removed or one was installed, perform axle alignment => [ Work Procedure, Vehicle Alignment Overview ] See:
Alignment/Service and Repair/Work Procedure, Vehicle Alignment Overview.
-
Install wheel and tighten.
-
On vehicles with air suspension, position vehicle on wheels. Refer to => [ Positioning Vehicle on Hoist and Wheels ] See: Suspension/Service and
Repair/Procedures/Positioning Vehicle on Hoist and Wheels.