Q7 Quattro V6-3.6L (BHK) (2007)
-
Install tools and bonded rubber bushings onto wheel bearing housing, as shown in illustration.
1. Nut (T10230/2)
2. Press piece (T10230/13)
3. Thrust pad (T10230/6)
4. Bonded rubber bushing
5. Press piece (T10230/8)
6. Tube (T10230/3)
7. Thrust plate (T10230/7)
8. (VAS 6178)
-
Press in bonded rubber bushing until stop.
By doing this, core of bonded rubber bushing is pressed in by (T10230/6) - arrow - more than is required. However, this is necessary so that bonded
rubber bushing lip makes contact with control arm on outside. After loosening (VAS 6178), bonded rubber bushing core settles into correct position.
-
Remove wood block from between wheel bearing housing and lower control arm.
-
Press wheel bearing housing in - direction of arrow -.