Q7 Quattro V6-3.6L (BHK) (2007)
/Page-3470003.png)
Checking ATF level and topping off
‹› The ATF level is checked at the ATF check hole.
‹› The ATF level is correct if a small amount of fluid drips out of the check hole (this is normal as the fluid expands as it heats up) at an ATF
temperature between 35° and 45°C (for hot countries 50°C).
-
To ensure vehicle is absolutely level, drive onto a 4-column lifting platform or over a service pit.
-
Fill reservoir of the ATF Filler Tool (V.A.G 1924) with ATF for automatic transmission 0AT; ATF specification => [ Capacities ] See:
Specifications/Capacity Specifications.
-
Secure ATF Filler Tool (V.A.G 1924) reservoir as high as possible on vehicle.
-
Remove screws and remove rear sound insulation - 2 -. Start engine and run at idle.
-
With engine idling, depress the brake pedal and shift the selector lever through all the selector lever positions, leaving the selector lever in each
position for at least 10 seconds.
-
Place old oil collecting and extracting device (V.A.G 1782) beneath transmission.
test temperature: 35°C to 45°C
-
When ATF temperature of 35°C is reached, remove ATF inspection plug - arrow - and drain off any excess ATF.
