Q7 Quattro V6-3.6L (BHK) (2007)
CAUTION!
Do not damage or scratch selector shaft running surface.
-
Pierce through shaft seal with a small screwdriver or scriber and pull out.
Installing
Install in reverse order of removal, note the following:
-
Lubricate outer circumference and space between sealing lips with ATF.
‹› Installation position: Open side of shaft seal faces transmission.
-
Press new shaft seal onto selector shaft.
-
Press on new shaft seal as far as stop using Thrust Piece (T10135) and assembly lever - A - or plastic hammer without twisting seal.
-
Drive spring pin back onto removed selector shaft lever in opposite direction to lever.
-
Slide selector shaft lever onto selector shaft, align and drive in spring pin.