Q7 Quattro V6-3.6L (BHK) (2007)
Shifter A/T: Removal and Replacement
Selector Lever Sensor System Control Module with Tiptronic Switch
Selector Lever Sensor System Control Module with Tiptronic Switch
‹› Selector Lever Sensor System Control Module (J587) with Tiptronic Switch (F189) are combined in one component.
Removing
-
Remove selector lever handle => [ Selector Lever Handle ] See: Selector Lever Handle.
-
Remove Selector Lever Transmission Range (TR) Position Display (Y26) => [ Selector Lever Transmission Range Position Display ] See:
Selector Lever Transmission Range Position Display
-
Remove installation frame with Multimedia Control Head (E380) - 1 -.
-
Disconnect electrical connector - 1 -.
-
Remove screws - arrows - and remove Selector Lever Sensor System Control Module (J587) with Tiptronic Switch (F189).
Installing
Install in reverse order of removal, note the following:
Torque specifications: => [ Selector Mechanism, Assembly Overview ] See: Selector Mechanism, Assembly Overview
-
Guide Selector Lever Sensor System Control Module (J587) with Tiptronic Switch (F189) over selector mechanism function unit and tighten
screws - arrows - to specified torque.