Q7 Quattro V6-3.6L (BHK) (2007)
-
Remove selector mechanism shift unit upward.
-
Remove center bracket upward, it must not be installed again.
‹› The center bracket is only needed for factory production.
Installing
Install in reverse order of removal, note the following:
Torque specifications: => [ Selector Mechanism, Assembly Overview ] See: Selector Mechanism, Assembly Overview
-
Insert selector mechanism shift unit from above into opening.
‹› Ensure seal is seated correctly on selector mechanism shift unit.
-
Insert selector lever cable - 3 - through hole in selector mechanism shift unit.
-
Tighten screws - arrows -.
-
Insert retaining hooks - 1 - and - 2 -.
-
Carefully insert boot - arrow - on selector lever cable all around in selector mechanism shift unit.