Q7 Quattro V6-3.6L (BHK) (2007)
-
Pull out sealing ring for flange shaft using slide hammer-complete set VW 771 and additional part for VW771 771/37 -
Installing
-
Lightly oil new sealing ring on outer circumference.
-
Drive in new seal up to stop.
-
Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1.
Before installing flange shaft, check dust cap for damage. Replace dust cap if necessary.
-
Remove old circlip - A - from groove in flange shaft using pliers.
B - Protective jaws
-
Insert new circlip in groove of flange shaft, being careful not to over-stretch circlip.
-
Drive in flange shaft using a plastic head hammer.
-
Install front final drive.
-
Check gear oil in front final drive.