Q7 Quattro V6-3.6L (BHK) (2007)
Please note:
Offset of (T10205/9) must point toward wheel bearing housing.
1. Threaded rod M20 (T10205/8-1)
2. Threaded nut M20 (T10205/8-2)
3. Hydraulic cylinder (VAS 6178)
4. Wheel bearing
5. Press piece (T10205/7)
6. Press piece (T10205/9)
7. Threaded nut M20 (T10205/8-2)
8. Threaded rod M20 (T10205/8-1)
-
Connect pressure gauge w/connection (VAS 6179/1) between (VAS 6178) and hydraulic line of (VAS 6178).
Pressures, described in the following, apply only to the hydraulic cylinder (VAS 6178).
Shortly before pressing-in procedure is completed, readout pressure must be between 100 and 190 bar.
Maximum pressure must not exceed 310 bar.
-
Press wheel bearing in until stop.
-
Install circlip.
Wheel hub, pressing in