Q7 Quattro V6-3.6L (BHK) (2007)
Differential Carrier Support: Service and Repair
Bonded Rubber Bushing at Front Housing, Pulling Out and In
Bonded Rubber Bushing at Front Housing, Pulling Out and In
Special tools, testers and auxiliary items required
‹› Thrust piece (VW 442)
‹› Sleeve (30 - 14)
‹› Alignment fixture (3301)
‹› Alignment fixture (3346)
‹› Alignment fixture (3347)
‹› Thrust pad (VW 512)
‹› Thrust piece (VW 554)
‹› Alignment fixture (3253)
‹› Alignment fixture (T10030)
-
Pull out bonded rubber bushing.
It is important to grease spindle (3346/2) with Molybdenum grease before using.
-
To do so, place special tool (3346/1) with flat shoulder facing toward bonded rubber bushing onto the spindle (3346/2).
-
Pull in bonded rubber bushing - A - until it is centered in front final drive housing.