Q7 Quattro V6-3.6L (BHK) (2007)
-
Release connector - D - and remove from Shift Lock Solenoid N110.
-
Release connector - E - and remove upward.
-
Press tab - C - in direction - arrow 1 -.
-
Remove second microswitch - B - in direction - arrow 2 -.
-
Disengage electrical line at selector mechanism - arrow A -
Installing
Install in reverse order of removal, note:
Note:
^
Lubricate bearing areas and slide surfaces with polycarbamide grease G 052 142 A2.
-
Guide microswitch on longer electrical line into opening under parking lock button in selector mechanism.
-
Guide shift gate - 1 - from below.
^
Shift gate selector lever in "S" position (as shown in illustration).
-
Insert microswitch - B - in shift gate and secure it with retaining pins - A -.
Note:
^
Microswitch must lie flush on all sides.
-
Engage electrical line in tab - arrow C -.
Note:
^
Retaining screws - A - secure microswitch - B - in shift gate.
^
Ignition key removal lock does not function correctly if microswitch is not inserted correctly or properly secured.