Q7 Quattro V6-3.6L (BHK) (2007)
Windshield Washer Switch: Service and Repair
Windshield Wiper/Washer Switch E22, Removing And Installing
Removing
-
Remove Steering Column Switch Module (SCSM).
NOTE: Steering must be in center position (wheels in straight ahead position) when removing and installing return spring with slip ring.
-
Carefully release catches - arrows -.
-
Remove airbag spring/spiral spring with slip ring - 2 - with Steering Angle Sensor G85 - item 1 - from Steering Column Switch Module (SCSM).
-
Remove screws - 1 - and - 2 - and remove Windshield Wiper/Washer Switch E22 - item 3 - from steering column switch module - arrow -.
Installing
Install in reverse order, observing the following:
-
Make sure all fasteners and electrical connectors are properly engaged.
-
Install Steering Column Switch Module (SCSM).
Tightening torque
Windshield Wiper/Washer Switch E22 to Steering Column Electronic Systems Control Module J527: 0.65 Nm