R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Wiper Control Module: Service and Repair
Windshield Wiper Motor With Front Passenger Windshield Wiper Motor Control Module
Windshield Wiper Motor with Front Passenger Windshield Wiper Motor Control Module
General information
The front windshield wiper system consists of two mechanically independent systems. Each wiper arm is operated by a separate motor. The wiper
motor control modules ensure the wipers move together.
Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] See: Wiper and Washer Systems/Service Precautions.
Removing
-
Remove wiper arms. Refer to => [ Windshield Wiper Arms ] See: Wiper and Washer Systems/Wiper Arm/Service and Repair.
-
Remove the luggage compartment seal - 2 - in the bumper trim area.
-
Loosen the quick-release fasteners - 1 and 4 -.
-
Pull the bumper trim - 3 - up - arrow A -. This releases the retaining tabs - arrows -.
-
Remove the rubber strip - 2 -.
-
Loosen the quick-release fasteners - arrows -.
-
Remove the headlamp/wheel housing trim - 1 - from the retaining groove in the luggage compartment liner and guide it out at the front lid hinge.