R8 Quattro Coupe V10-5.2L (BUJ) (2010)
/Page-2089004.png)
-
Tighten the seat occupied recognition control module (J706) with the bolts - 2 -.
-
Connect connector - 6 -.
-
Install cover with upholstery on seat pan, refer to => [ Seat Pan Cover and Upholstery ] See: Body and Frame/Seats/Service and
Repair/Overhaul/Seat Upholstery, Covers/Seat Covers and Upholstery.
Further installation is performed in the reverse order of removal.
CAUTION!
Ensure that electrical connections are pushed in as far as stop and engage with a click.
-
Switch on ignition.
CAUTION!
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not
repaired correctly. Individuals must not be inside the vehicle when connecting the battery.
-
Connect battery ground cable with ignition switched on.
‹› If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.
-
When installing a new service kit, run the following program in Guided Fault Finding under "Airbag" after installing the passenger seat:
‹› Seat Occupied Recognition Control Module (J706) basic setting
