R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Tightening specifications, refer to => [ Lower Transverse Link with Retaining Bracket, Stabilizer Bar, Coupling Rod and Level Control System
Sensor Assembly Overview ] See: Control Arm/Service and Repair/Front Suspension/Lower Transverse Link With Retaining Bracket, Stabilizer Bar,
Coupling Rod and Level Control System Sensor Assembly Overview.
Tightening specifications, refer to => [ Wheel Bearing Housing and Wheel Bearing Unit Assembly Overview ] See: Rear Knuckle/Service and
Repair/Front Suspension.
-
Tighten the drive axle to wheel hub threaded connection, refer to => [ Threaded Connection Between Drive Axle and Wheel Hub, Loosening and
Tightening ] See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Constant Velocity Joint/Service and
Repair/Removal and Replacement/Threaded Connection Between Drive Axle and Wheel Hub, Loosening and Tightening.
-
On vehicles with electronically-controlled damping (Audi magnetic ride), reprogram the control position using the (VAS 5051B).
-
Axle alignment is required, see table. Refer to => [ When Vehicle Alignment is Necessary ] See: Alignment/Description and Operation.