R8 Quattro Coupe V10-5.2L (BUJ) (2010)
3
Gear Selection Valve 1 (N284)
‹› Removing and installing, refer to => [ Clutch Actuator Valve and Gear Selection Valves ] See: Removal and Installation/Clutch Actuator
Valve and Gear Selection Valves
‹› Depending on the version, a strainer is still installed in front of Gear Selection Valve 1 (N284) (refer to => [ (Item 30) Strainer ]). The
auxiliary strainer cannot be installed on versions without the strainer.
4
Bolt
‹› 3.6 Nm
5
Gear Selection Valve 2 (N285)
‹› Removing and installing, refer to => [ Clutch Actuator Valve and Gear Selection Valves ] See: Removal and Installation/Clutch Actuator
Valve and Gear Selection Valves
‹› Depending on the vehicle, different versions are installed, with and without a strainer
6
Bracket
‹› For the cover
7
Bolt
‹› 22 Nm
‹› Quantity: 3
8
End cover on R tronic shift actuator
9
O-ring
‹› Replace
10
Pressure piston
11
Shaft seal
12
Oil seal
‹› Replace
13
Hydraulic Pressure Sensor (G270)
‹› 15 Nm
‹› Refer to => [ Hydraulic Pressure Sensor ] See: Manual Transmission/Transaxle/Gearshift Actuating System - M/T/Hydraulic Fluid Pressure
Sensor / Switch - M/T/Service and Repair
14
Bolt
‹› 3.6 Nm
15
Gear Selection Valve 3 (N286)
‹› Removing and installing, refer to => [ Clutch Actuator Valve and Gear Selection Valves ] See: Removal and Installation/Clutch Actuator
Valve and Gear Selection Valves
‹› Depending on the vehicle, different versions are installed, with and without a strainer
16
O-ring
‹› Replace