R8 Quattro Coupe V8-4.2L (BYH) (2009)
/Page-1889002.png)
-
Remove the A/C pressure/temperature sensor - B - from the refrigerant line.
Installing
‹› Tightening specification: 5 Nm.
Installation is done is reverse order, observe the following:
-
Replace the O-ring - C -, refer to => [ Refrigerant Circuit O-Rings ] See: Service and Repair/Procedures/Refrigerant Circuit O-Rings.
-
Tighten the A/C pressure/temperature sensor.