RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
7
-
Support piece
NOTE: When turning adjustment screw, make sure mounting bracket raises.
-
Before installing bumper cover, adjust support piece adjusting screw.
-
Tighten adjustment screw to 2 Nm with a long Torx wrench - T30 - through holes in cover - arrows -.
-
To disassemble, drill off pop rivet heads.
8
-
Front spoiler
-
Remove screws - 10 -.
-
Slide spoiler back slightly out of bumper cover guides.
-
Remove spoiler downward.
9
-
Expanding rivet
10
-
Screw
-
2 Nm
11
-
Spring nut
Air intake grille for S4
-
Remove bolt - arrows -.
-
Press air intake grille - 2 - on the inside of bumper cover - 2 - as shown toward rear out of locking mechanism.
-
Remove air intake grille forward from bumper cover.