RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Unclip decorative panel - 4 -.
-
Pull off decorative panel - 4 - toward front.
-
Remove bolt - 2 - (Qty. 4) from door trim - 8 -.
-
Unclip door trim - 8 -. Refer to => [ Door Trim Securing Clip ].
-
Raise door trim - 8 - upward approx. 20 cm out from door shell.
-
Disengage Bowden cable for interior door mechanism. Refer to => [ Release, Disengaging ].
-
Disconnect electrical harness connectors. Refer to => [ Connector On Window Regulator Control Module ]
‹› Installing:
To install, perform the steps used in removal in reverse order. Note the following:
-
When installing, speed nuts - 1 - (Qty. 4) for expanding nuts - 7 - (Qty. 4) must be clipped in.
-
When installing, door trim must be pressed in center toward door shell.
Release, Disengaging
-
Remove circlip - 3 -.
-
Pull release - 1 - out of guide - 2 - and disengage.
‹› When installing make sure that catch - 3 - faces upward.
Connector On Window Regulator Control Module