RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Convertible Top Position Sensor / Switch: Service and Repair
Convertible Top Position Switch (Open Position Switch F171 / Closed Position Switch F202),
removing
Convertible Top Position Switch (Convertible Top Open Position Switch F171 / Convertible Top Closed Position Switch F202), Removing
-
Remove rear side trim.
-
Disconnect electrical connector on Convertible Top Control Module J256.
-
Remove convertible top cable from guides and cable ties for body wall and convertible top frame.
-
Remove switch bolts - 1 -.
-
Carefully remove convertible top position switch from bolting point mounts.
NOTE:
-
The convertible top switch unit described is located on the right main guide.
-
The convertible top should be brought to the appropriate position to remove respective convertible top switch unit bolt.