RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
^
Always replace when changing pads
5 - Wheel bolts
^
Mount wheels
6 - Torx bolt
^
Tightening torque: 5 Nm
7 - Brake disc
^
Always replace both sides
^
Remove brake caliper prior to removing
^
Lubricate contact surfaces between brake disc and wheel hub with polycarbamide grease G 052 142 A2.
^
Make sure there is sufficient wear limit
8 - Hex socket head bolts, 75 Nm
^
M10×60
^
Always replace
9 - Brake carrier with guide pins and protective caps
^
Replacement carriers are supplied assembled and with sufficient grease on guide pins
^
If protective caps or guide pins are damaged, replace using repair kit. Use grease packet supplied to lubricate guide pins.
10 - Banjo bolt, 45 Nm
11 - Brake line with banjo union
^
Do not twist hose when installing
^
Remove from brake carrier to replace brake pads
^
Do not twist hose when installing
^
Do not disconnect brake hose when changing brake pads
^
Servicing brake calipers
12 - Seals