RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Installation position of alignment bushings
-
Check whether alignment bushings - arrows - are inserted at locations in guide frame as shown in the illustration.
Installing guide frame
-
Replace bolts - 1 to 20 -.
-
Tighten bolts for guide frame as follows:
-
Tighten bolts - 1 to 10 - to 30 Nm with torque wrench.
-
Tighten bolts - 11 to 20 - to 20 Nm with torque wrench.
-
Tighten bolts - 1 to 10 - to 50 Nm with torque wrench.
-
Tighten bolts - 11 to 20 - to 30 Nm with torque wrench.
-
Tighten bolts - 1 to 10 - 90 degrees (1/4 additional turn) using a rigid wrench.
-
Tighten bolts - 11 to 20 - 90 degrees (1/4 additional turn) using a rigid wrench.
-
Tighten cylinder block/guide frame sealing surface bolts, - highlighted in illustration but not numbered -, in a diagonal sequence to 9 Nm.