RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-837005.png)
-
Carefully loosen the oil pan upper section from the bond and press it off the cylinder block alignment bushings.
Installing
‹› Replace seals and O-rings.
CAUTION!
Wear safety glasses.
-
Using rotating plastic brush, remove any remaining sealant from oil pan (upper section) and at cylinder block.
-
Clean the sealing surfaces, they must be free of oil and grease.
‹› Note the expiration date of the sealing compound.
-
Cut tube nozzle at front marking (nozzle dia. approximately 2 mm).