RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Slowly lower rear cross member using engine/transmission jack V.A.G 1383 A until distance between rear cross member/chassis acquires
dimension - x -.
-
Dimension - x - = max. 60 mm
NOTE: Dimension - x - must not be exceeded, otherwise drive shaft joint and lines on bulkhead can be damaged.
-
Remove electrical harness connectors - 1 - and - 2 - from bracket at transmission.
-
Disconnect electrical harness connectors.
-
Remove heat insulation sleeve on wiring harness and free up individual electrical wires.
-
Remove bolts - 1 - and - 2 -.
-
Remove right front exhaust pipe strap.