RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
2 - Wheel bearing
‹› Interior diameter in tiered version
‹› Installation position: Larger internal diameter of wheel bearing faces wheel hub
‹› Pressing out => [ Pressing wheel bearing out of wheel bearing
housing ]
‹› Pressing in => [ Pressing wheel bearing in wheel bearing housing ]
3 - Cover plate
4 - Wheel hub
‹› Tiered version
‹› Pressing out => [ Wheel hub, removing ]
‹› Pressing in => [ Pressing wheel hub into wheel bearing ]
‹› Light construction wheel hub, refer to => [ Light Weight Wheel Hub Characteristics ] See: Steering and Suspension/Suspension/Rear
Knuckle/Description and Operation/Light Weight Wheel Hub Characteristics
5 - Torx bolt
‹› Tightening specification, refer to => Brakes and Traction Control See: Brakes and Traction Control
6 - Rubber bushing
‹› Removing => [ Rubber bushing, removing ] See: Steering and Suspension/Suspension/Rear Knuckle/Description and Operation/Stub Axle
Carrier, FWD,
‹› Installing => [ Rubber bushing, installing ] See: Steering and Suspension/Suspension/Rear Knuckle/Description and Operation/Stub Axle
Carrier, FWD,
Wheel hub, removing
‹› Wheel bearing housing must rest on machined bolt hole surface.
Pressing wheel bearing out of wheel bearing housing