RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Wiring Harness: Removal and Replacement
Primary Connector With Special Connector Systems
Primary Connector with Special Connector Systems
Procedure
NOTE: If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts.
Fasten contacts:
-
Guide release tool (that fits terminal housing) into release channel on terminal housing - arrow -.
-
Grasp contact at wire and push gently into terminal housing.
NOTE: By pushing contact in direction of terminal housing, contact retaining tabs are lifted off the housing shoulder and can be released using
release tool.
-
At the same time, push release tool in direction of terminal housing and pull released contact out of terminal housing - arrow -.
-
Remove release tool after removing contact from housing.
GT 150/280 contacts:
-
Guide release tool (which fits terminal housing) under retaining tab into terminal housing.
-
Push tool into terminal housing until it stops - arrow -.
-
Contact is ejected from the terminal housing.
-
Remove release tool after removing contact from housing.
Contacts without retaining tabs:
-
Insert release tool under retaining tab of terminal housing.
-
Push release tool through until it stops by gently lifting - arrow -.