RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Guide release tool (which fits terminal housing) into release channel on terminal housing.
-
Grasp contact at wire and push gently into terminal housing - arrow -.
‹› By pushing contact in direction of terminal housing, contact retaining tabs are lifted off the housing shoulder and can be released using release
tool.
-
At the same time, push release tool in the direction of terminal housing and pull released contact out of terminal housing - arrow -.
-
Remove the release tool after removing the contact from the housing.
Primary Connector with Special Connector Systems
Procedure
‹› If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts => [
Secondary Lock ].
Fasten contacts: