RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Slide fiber optic cable - 2 - into brass pin contact - 1 - as far as spring-loaded stop.
-
Slide fiber-optic cable further in up to fixed stop and close Crimping Pliers For Fiber-optic Cable (VAS 6223/2).
-
Open Crimping Pliers For Fiber-optic Cable and remove fiber-optic cable with brass pin contact.
CAUTION!
Do not excessively bend or kink fiber optic cables. (min. bending radius 25 mm).
-
Check proper attachment of brass pin contact - 2 - to fiber optic cable - 1 -.
‹› 4 crimp points must be visible at brass connection pin.
‹› The brass pin contact must not be able to be removed by hand from fiber-optic cable.
‹› End face of fiber optic cable is located 0.01 to 0.1 mm behind brass pin contact (visual inspection).
‹› Plug-in couplings are available for connecting fiber optic cables.
‹› For installing new fiber optic cable in wiring harness connector, refer to => [ Fiber Optic Cable, Separating from Wiring Harness Connector ].
Installing corrugated tube on fiber-optic cable